Table of Contents
Advertisement
22
A/V 5 connections
A/V 5 input cluster provides one 15-pin D-Sub female multimedia input and
two (left and right) audio inputs.
These inputs are verified to meet FCC Class A requirements for commercial
use. (See full statement on the backside of the safety instructions)
•
Connect one end of a cable (not supplied) to the multimedia device and the
other end to the
input on the rear side of the receiver or at the
A/V 5
input at the front of the receiver.
•
Fix the connectors firmly with the screws on the plug.
•
In case audio is required, connect audio cables (not supplied) to the audio
output of your multimedia device and to the
inputs next to the 15-pin input.
Daisy chaining
The active loop through facility makes it possible to make e daisy chain.
Connect all devices (maximum of two) before inserting the mains plug in the
wall socket.
•
Connect one end of another cable (not supplied) to the
rear of the receiver and the other end to a second display device.
•
In case audio is required, connect audio cables (not supplied) to the
outputs
(right) and
(left) for
R
L
second display service.
Multimedia display modes
• 640x480
31.468 kHz
• 640x400
31.468 kHz
• 640x350
31.468 kHz
• 640x480
35.000 kHz
Note: When the video signal is not recognizable and > 35 KHz is displayed, the
picture is muted.
(right) and
AUDIO R
A/V 5
and the other end of the cables to the
A/V 5
60 Hz
70 Hz
70 Hz
67 Hz
A/V 5
(left)
L
output in the
AUDIO
Advertisement
Table of Contents
