Philips 42PW9962 User Manual page 17

Volume
SOUND
Balance
Graphic Equalizer
Sound Style
Sound Mode
Loudness
Speech
Spatial
Headphone
Dolby Pro Logic Install
Left
Rear
Test
DOLBY
Center Volume
PRO LOGIC
Balance
INSTALL
Rear Volume
Surround Mode
Pro Logic
Dolby 3 Stereo
Hall
Off
Right
& Select Pro Logic in Surround Mode of the
Center
é Select Test On.
Rear
" Select Center Volume, Balance or Rear Volume and alter the selected
' Switch Test Off again.
*
Dolby* Pro Logic Install
Adjust the volume balance level of the speakers
Most programs will sound good with the volume balance between the center,
left, right and rear speakers in an equally loud position.
However, some programs may benefit from an adjustment of the level of the
respective speakers.
Which speakers are active depends on the selection you have made in the
Setup menu, p. 7, or on the Surround Mode selection you make below.
menu.
A steady noise tone is switched sequentially through the left, center, right and
rear speakers, for 2 seconds each. This enables you to adjust the volume of
the separate speakers.
The speakers activated light up in the on screen graphic.
adjustments until all speakers sound equally loud from the listeners position.
Surround mode
According to the broadcast sound modes, select the Dolby Surround Sound
possibilities:
Pro Logic (with Dolby Surround encoded broadcasting or video material)
In addition to the left and right front speakers, the center and the rear
surround speakers reproduce the Dolby Surround Pro Logic sounds, when the
movie or program is marked with
This mode is especially recommended for such programs or movies.
Dolby 3 Stereo (using only the 3 front speakers for enhanced stereo
reproduction)
Note there is no Dolby 3 Stereo sound signal.
This mode is intended if no rear surround speakers are connected although
you may wish to take advantage of the benefits of surround sound.
The Dolby Surround encoded sources are reproduced from the left, the right
and the center speakers. Surround information is now reproduced in the left
and right front speakers.
Hall (without Dolby Surround broadcasting)
This mode is recommended when you wish to add surround sound to a
broadcast which is not encoded Dolby Surround or to a mono or poor stereo
broadcast. The center speaker does not produce any signal.
Off
This mode reproduces only the left and right front sound signals.
This mode is recommended if no surround sound is desired or if there is no
surround broadcasting.
You only hear a stereo sound if the broadcast which you are watching or
listening to is transmitted in stereo sound.
•
Press the key repeatedly to switch off the menu.
SOUND
'Dolby' 'Pro Logic' and the double-D symbol
Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories Licensing Corporation.
DOLBY PRO LOGIC INSTALL
Dolby Surround.
are trademarks of Dolby
13