Table of Contents
Advertisement
4.
Before installing a solid-state drive, be sure that a thermal pad is installed on the system board under
the drive as shown in the following illustration. When replacing the cover, be sure to insert the edges of
the cover into the six clips positioned around the drive.
To install the solid-state drive, reverse the removal procedures.
NOTE:
Solid-state drives are designed with a notch to prevent incorrect insertion.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-6
Touchpad description and part number
Description
Touchpad
Touchpad cable
Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the touchpad:
1.
Disconnect the touchpad cable from the ZIF connector on the touchpad (1).
2.
Lift the Mylar that covers the screws on the top of the touchpad (2).
3.
Remove the conductive tape from the top of the touchpad (3).
4.
Remove the three Phillips M1.6 × 1.6 screws (4) from the touchpad.
Preparation for disassembly on page
Bottom cover on page
Battery on page
28).
27).
Spare part number
N24436-001
N24421-001
25).
Touchpad
33
Advertisement
Table of Contents
