Table of Contents
Advertisement
JM icron RAID Introduction
Creating and Deleting RAID sets with BIOS Utility
Be sure to set RAID mode for the Onboard JMB361 Mode of Integrated Periph-
erals in BIOS before configuring the JMicron BIOS utility. After that press F10 to save
the configuration and exit. During boot up (POST), press CTRL+J to enter the JMicorn
BIOS RAID utility.
The RAID Utility menu screen will be displayed. A brief description of each section is
presented below.
M ain M enu
The Main Menu in the upper left corner is used to choose the operation to be
performed. The selections are:
Create RAID set - is used to create a new legacy RAID set.
Delete RAID set - is used to delete a legacy RAID set.
Revert HDD to non-RAID - is used to revert an existed-RAID HDD to non-RAID.
Save And Exit Setup - save all settings and exit the BIOS utility.
Exit W ithout Saving - exit the BIOS utiltiy without any saving.
Hard Disk Driver List
The menu shows the model number and capacities of the drives physically
attached to the SATAII & PATA ports.
RAID Disk Driver List
The menu shows the current configuration of RAID set.
6-3
Advertisement
Table of Contents
