NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Place the power-supply unit on the chassis.
2. Slide the power-supply unit towards the back of the chassis until it snaps into place.
3. Align the screw holes on the power-supply unit with the screw holes on the chassis.
4. Replace the three screws (#6-32xL6.35) that secure the power-supply unit to the chassis.
5. Route the power-supply unit cable through the routing guides inside the chassis.
6. Connect the power-supply unit cables (ATX 1 and ATX 2) to the system board.
7. Rotate the side-chassis towards the computer until it snaps into place.
Post-requisites
Replace the
computer
cover.
Replacing the power-supply unit
computer. After working inside your computer, follow the instructions in
Replacing the power-supply unit
33
After
53