Error Messages - aircon Eco Power 9000 Instruction Manual

ERROR MESSAGES

The mobile air conditioner is equipped with a 3-minute compressor-delay system which means
This affects the switching on of the unit (POWER) as well as switching over from one function to
ERROR/ CAUSE
PROBLEM
Can I switch the
unit on
immediately after
unpacking it?
When switching Production-related
on the unit I sense cause or incorrect
a smell. What storage of unit at e.g.
should I do. dusty areas.
Can I operate the
unit WITHOUT the
extract air hose.
At which intervals
should the
activated carbon
filter of the unit
be replaced?
How can I
increase the
efficiency of the
unit?
Compressor does
not activate
unit deactivates.
How is the m² or
m³ data of the
manufacturer
calculated
unit does not
cool correctly
E1 Room temperature
outside the function
range:
the compressor needs 3 minutes to start.
the next, e.g. dehumidify to cooling or heating.
REMEDY
No.
The unit must be placed upright for at least 24 hours
after every transport. Otherwise the compressor may be
damaged and there is no capacity.
Odour development can arise on first use and after a
longer period of non-use by storing in unsuitable areas
(e.g. dusty areas).
Run the unit for ½ a day. The smell will disappear after a
while. In the case of intensive odour development, air the
room.
No.
To achieve temperature adjustments, surplus heat or
coldness must be discharged.
To use the purpose of the filter fully, it should be
replaced every 6 months.
External circumstances exist which may impact the
efficiency of the unit. Room insulation, use of
wall/window adapter, ratio of window space (solar
radiation), operation of electrical units in the room (EDP),
presence of several persons in the room. You can
increase the efficiency of the unit accordingly by
adjusting such circumstances.
Depending on ambient temperatures and unit type it may
take approx. 10 minutes after starting the compressor
until the cooling/heating capacity is reached.
On reaching the set required temperature, the unit
switches off automatically.Check manual setting of the
required temperature as well as the TIMER setting.
The m² or m³ data of the manufacturer for the various
units are average values related to a room height of 2.5
metres. It must be considered that such data can be
clearly underscored or exceeded under certain
circumstances. Circumstances which work against
efficiency of the units include e.g. bad insulation of the
building, large window areas, south facing, attic
apartment, many additional heat sources, such as e.g.
number of persons, EDP, light, kitchen units, washing
units etc.
You achieve the most effective and economical cooling
comfort if you already cool the room to be cooled when
the room temperature is not yet heated up. Air
conditioners operate more effectively if the temperature
is to be maintained. To drastically cool the air and
inventory in a fully heated room requires much more time
and energy.
Observe all data in these operating instructions
concerning function range.
39