Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 4010-D Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 36
Figure 37
(Figure 36)
(Figure 37)
(Figure 38)
(Figure 38)
(Figure 38).
Front Cutting Unit
•
Castor fork shaft bushings (2)
•
Spindle shaft bearings (3) (located under the pulley)
(Figure 40)
•
Idler arm pivot bushings (2)
g009246
g004687
39
Figure 38
(Figure 39)
(Figure 40)
Figure 39
g011499
g011557