Checking Fuel Filter; Inspecting Idling Speed - Yamaha F40B Owner's Manual

Maintenance
Checkpoints
Fuel system parts leakage
G
Fuel line joint leakage
G
Fuel line cracks or other damage
G
Fuel connector leakage
G
EMU28990

Checking fuel filter

Check the fuel filter periodically. The fuel fil-
ter is a one piece, disposable type. If foreign
matter is found in the filter, replace it. For re-
placement of the fuel filter, consult your
Yamaha dealer.
51
EMU29040

Inspecting idling speed

EWM00450
WARNING
Do not touch or remove electrical parts
G
when starting or during operation.
Keep hands, hair, and clothes away
G
from the flywheel and other rotating
parts while the engine is running.
2-hp models: The propeller rotates
G
whenever the engine is running. Do not
move the throttle control lever from the
start position during warm-up. The boat
could unexpectedly start to move,
which could result in an accident.
ECM00490
CAUTION:
This procedure must be performed while
the outboard motor is in the water. A
ZMU04082
flushing attachment or test tank can be
used.
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
outboard motor in the water.
1. Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly.
2-hp model: Warm the engine with the
throttle in the start position or less. If the
outboard is mounted on a boat, be sure
the boat is tightly moored.
NOTE:
Correct idling speed inspection is only possi-
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty ver-
ifying the idle speed, or the idle speed re-
quires adjustment, consult a Yamaha dealer
ZMU04083