Something Not Working - Zanussi ZWH7100C User Manual

126.2936.41.qxd 31/10/08

Something not working

IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved
easily without calling out an engineer. Before contacting your local Service Centre, please carry
out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes and one of the
following alarm codes appears on the display to indicate that the
machine is not working:
• E10: problem with the water supply
• E20: problem with water draining
• E40: door open.
Once the problem has been eliminated, press the Start/Pause button to restart the programme.
If after all checks, the problem persists, contact your local Service Centre.
Malfunction
The washing machine does not start:
The machine does not fill:
44
14:40 Página 44
The door has not been closed. E40.
• Close firmly the door.
The plug is not properly inserted in the power
socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
Start/Pause button has not been depressed.
• Please turn the selector dial and press the
Start/Pause button again.
The delay start has been selected.
• If the laundry are to be washed immediately,
cancel the delay start
The water tap is closed. E10.
• Open the water tap.
The inlet hose is squashed or kinked. E10.
• Check the inlet hose connection.
The filter in the inlet hose is blocked. E10.
• Clean the water inlet hose filter.
The door is not properly closed. E40.
• Close firmly the door.
Possible Cause / Solution