Chevrolet Blazer 2022 Owner's Manual page 204

Chevrolet Blazer Owner Manual (GMNA-Localizing-MidEast-16401983) -
2023 - CRC - 6/17/22
204 Driving and Operating
Stationary or Very Slow-Moving Objects
Warning
ACC may not detect and react to stopped
or slow-moving vehicles ahead of you. For
example, the system may not brake for a
vehicle it has never detected moving. This
can occur in stop-and-go traffic or when a
vehicle suddenly appears due to a vehicle
ahead changing lanes. Your vehicle may
not stop and could cause a crash. Use
caution when using ACC. Your complete
attention is always required while driving
and you should be ready to take action
and apply the brakes.
Irregular Objects Affecting ACC
ACC may have difficulty detecting the
following objects:
Vehicles with cargo extending from the
back end.
Non-standard shaped vehicles, such as
vehicle transport, vehicles with a side car
fitted, or horse carriages.
Objects that are close to the front of your
vehicle.
ACC Automatically Disengages
ACC may automatically disengage and the
driver will need to manually apply the
brakes to slow the vehicle when:
The sensors are blocked.
The Traction Control System (TCS) or
StabiliTrak/ESC system has activated or
been disabled.
There is a fault in the system.
The radar falsely reports a blockage when
driving in a desert or remote area with
no other vehicles or roadside objects.
A DIC message may display to indicate
that ACC is temporarily unavailable.
The ACC indicator will turn white when ACC
is no longer active.
In some cases, when ACC is temporarily
unavailable, regular cruise control may be
used. See Switching Between ACC and
Regular Cruise Control in this section.
Always consider driving conditions before
using either cruise control system.
Notification to Resume ACC
ACC will maintain a following gap behind a
detected vehicle and slow your vehicle to a
stop behind that vehicle.
If the stopped vehicle ahead has driven
away and ACC has not resumed, the vehicle
ahead indicator will flash as a reminder to
check traffic ahead before proceeding. In
addition, the left and right sides of the
Safety Alert Seat will pulse three times,
or three beeps will sound. Touch the
Settings icon on the infotainment home
page. Select Vehicle to display the list of
available options and select Alert Type and
Adaptive Cruise Go Notifier in Collision/
Detection Systems .
When the vehicle ahead drives away, press
RES+ or press the accelerator pedal to
resume cruise control. If stopped for more
than two minutes or if the driver door is
opened and the driver seat belt is
unbuckled, the ACC automatically applies the
Electric Parking Brake (EPB) to hold the
vehicle. The EPB status light will turn on.
See Electric Parking Brake 0 193. To resume
ACC and release the EPB, press the
accelerator pedal.
A DIC warning message may display
indicating to shift to P (Park) before exiting
the vehicle. See Vehicle Messages 0 111.