Declaration Of Conformity; Transport, Storage, Acceptance - S&P DUOVENT MODULAR DV Instruction Manual

3.6 DECLARATION OF CONFORMITY

This type of product was tested by the Authorized Person of EZU Prague, and a certificate was issued for it. For a unit of the above type, within
the meaning of Act No. 22/1997 Coll. as amended, issued a "Declaration of Conformity".

4. TRANSPORT, STORAGE, ACCEPTANCE

On the loading surface of the vehicle, the unit must be sufficiently secured against slipping and tipping over.
The unit is wrapped in PE foil and placed on transport beams. The unit is fixed to the transport beam by means of sheet metal clamps and
screws. The unit is always shipped in 3 separate blocks. The connection of individual blocks is carried out only after transport to the destination in
the building (air conditioning engine room or roof).
CAUTION!
!
The holes in the frame and legs are not intended for the unit
hinging.
When loading and unloading with a forklift, lift the unit by attaching it to the bottom edge of the base frame or through pre-prepared holes in the
unit frame. When transporting the unit, it is necessary to support the unit on the underside over the entire surface to prevent damage and to pay
attention to the condensate outlet opening on the underside of the unit.
transport of the DUOVENT
detail of the transport beam expedition blocks of DUOVENT
®
MODULAR unit block using a forklift
Ventilation units with heat recuperation
®
DUOVENT MODULAR DV/RV
®
MODULAR DV/RV units
15