Diagnostic Lcd Message - lifeSMART ESTRELLA L Owner's Manual

1. Press and hold the Light button for 5 seconds
2. Press the Light button several times until St, Ec, SL, or nt is displayed.
3. Use the Plus or Minus button to choose between the Modes.
St = Standard Mode, Ec = Economy Mode, SL Sleep = Mode and nt = Quiet Mode.
4. Wait 15 seconds to allow the exit timer to expire and store the setting.
To Program the Quiet Mode the following is required:
Once in the nt mode, press the Light button then press the Up/Down button to change the amount of time
you do not want the jet pump to come on between F2 and F1.
Message Meaning
No message on display.
Power has been cut off to the spa.
HL The system has shut the heater
off because the temperature at the
heater has reached 119°F (48°C).
Do not enter the water!
AOH Temperature inside the equipment
compartment is too high 194F
(90°C), causing the internal
temperature in the control system to
increase above normal limits.
Prr A problem is detected with the
temperature probe.
OH The water temperature in the spa
has reached 108°F (42°C). Do not
enter the water!
Hr An internal hardware error has been
detected.
FLO No water flow is detected by the
control system but flow is expected.
WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.
Do not attempt service of the control box. Contact Customer Service at (888) 961-7727
Ext. 8440 for assistance. Follow all owner manual power connection instructions. Installation must
be performed by a licensed electrician and all grounding connections must be properly installed.
CONTROL PANEL OPERATION

DIAGNOSTIC LCD MESSAGE

Action Required
The control panel will be disabled until power
returns. Spa settings will be preserved until
next power up.
DO NOT ENTER THE WATER. Remove the
spa cover and allow the water to cool down,
then shut power off and power your spa up
again to reset the system.
If spa does not reset, shut off the power to the
spa and call Customer Service at
(888) 961-7727 Ext. 8440 or at ahsservice@
watkinsmfg.com.
Open equipment compartment and wait until
error clears.
Call Customer Service at (888) 961-7727 Ext.
8440 or at ahsservice@watkinsmfg.com.
Remove the spa cover and allow the water to
cool down to a lower temperature. Call
Customer Service if problem persists.
Call Customer Service. at (888) 961-7727 Ext.
8440 or at ahsservice@watkinsmfg.com.
Make sure that the jet pump is running and
water is flowing; check and clean filters; make
sure water valves are open; make sure spa
has a proper water level. If problem persists,
call Customer Service at (888) 961-7727 Ext.
8440 or at ahsservice@watkinsmfg.com.
13