Control Panel Operation; Display Overview; Temperature Adjustment - lifeSMART ESTRELLA L Owner's Manual

INITIAL START-UP -
a 2 minute Startup Mode. Different codes will display on the screen. Once Startup
Mode completes, the actual temperature is
displayed on the screen, and the spa will
then begin to heat, maintain the
water temperature and the first
filter cycle will start 5 minutes
later. Your spa has been designed
so that it will automatically heat the water
to the factory set temperature of 100°F
(38°C) unless you set the spa to a different
temperature. If power is disconnected from
the spa, it will automatically revert back to
the last saved set temperature when power is reapplied. NOTE: Some models only have Jets 1

DISPLAY OVERVIEW

Pumps icon
The "Pump" indicator lights up when
the pump is in high speed, and flashes
when the pump is in low speed.
Some models only have 1 pump.
Service icon
A problem has
been detected. Do
not enter the water!
Spa service is
required.
Light icon
The "Light" icon lights up
when the light is on.

TEMPERATURE ADJUSTMENT

The temperature can only function between 80°F - 104°F (26.5°C - 40°C). The last measured
temperature will constantly display on LCD.
Press the Up/Plus or Down/Minus buttons to display the set temperature
(desired temperature) and indicator
again, the set temperature will increase or decrease depending on which
button is pressed. After five seconds, the LCD will automatically display the
current spa temperature.
The "heater" indicator
more heat, but the heater is not on. Once set temperature is reached the indicator
the low speed of the jet pump turns off after 30 seconds (if not in filter cycle).

CONTROL PANEL OPERATION

When the spa is first powered up the control system begins
Mode
Temperature
& message digits
Heater icon
The "Heater" icon lights up when the heater is on. It
flashes when:
1- there is a call for heat and heater has not started yet,
2- heater has just turned off and element is cooling
down or
3 - not enough current available to start heater
. Each time either button is pressed
lights up when the heater is on. It flashes when there is a request for
Jets 1 Jets 2 Lights
Filter Cycle icon
The "Filter Cycle" icon lights
up when filter cycle is on. The
icon flashes if the filter cycle is
disrupted.
˚F/ ˚C
10
Temp Up/
Plus
Temp Down/
Minus
Smart Winter Mode icon
The "SWM" icon
automatically turns on
when freeze protection
is active. It flashes while
system purges the spa
plumbing.
Set Point icon
The "Set Point" icon
automatically turns on
when set point setting
menu is activated.
shuts off and