Walker C23i Operator's Manual page 27

C23i
Deck Support Arms
Carrier Frame
Tube Sockets
Mower Deck Installation
4. Engage the deck carrier frame tube sockets
on the tractor support arms. Refer to Mower
Deck Installation photo for socket location.
Slide the deck onto the support arms approxi-
mately 3 in. (76 mm).
5. Reaching under the tractor, slide the PTO
coupler tube onto the tractor's PTO drive shaft.
Make sure the ring has "snapped" securely on
the spline shaft.
IMPORTANT: To prevent damage to the mow-
er, make sure the PTO quick disconnect is
securely locked on the tractor, with the locking
balls fully seated in the groove and the ring in
the locked position (refer to the Quick Dis-
connect Ring "Locked" Position illustra-
tion). After installation, pull on the PTO cou-
pler to check for security.
Coupler Ring in
Released Position
Quick Disconnect Ring "Released" Position
PTO Drive
Shaft
PTO Coupler
U-Joint
Internal Balls
Locked on Shaft
PTO Coupler
U-Joint
Quick Disconnect Ring "Locked" Position
IMPORTANT: When installing the DS52 Mower
deck, make sure to retract the dolly wheel
after mounting the deck on the tractor.
6. Slide the deck the rest of the way on the deck
arms. If the deck is collection style, the dis-
charge chute will need to be aligned and
connected to the blower inlet during the last 2
in. (51 mm) of slide action on the support
arms.
NOTE: Raising the mower seat panel may be
helpful in fitting and guiding the deck chute
into the blower.
7. Install the hitch pin through the hole on the
end of each support arm to lock the deck in
place. Two (2) hitch pins are included in the
Owner's Packet of materials.
Hitch Pins Lock Deck
on Support Arms
Use Hitch Pins to Lock Deck on Support Arms
WARNING
Failure to install the hitch pins will result in
the deck disconnecting from the tractor
during operation.
Assembly Instructions
PTO Drive
Shaft
Coupler Ring in
Locked Position
23