Walker C23i Operator's Manual page 17

C23i
14. The maximum recommended slope operat-
ing angle is 15 degrees or 27% grade.
When operating the machine on a slope, re-
duce speed and use caution to start, stop, and
maneuver. To prevent tipping or loss of control
of the machine, avoid sharp turns or sudden
changes in direction. Do not operate the
machine on a slope greater than 15 de-
grees.
15. Never adjust cutting height with the engine
running. Before adjusting cutting height or
servicing, disengage the blade clutch (PTO),
engage parking brake, stop the engine, and
remove the ignition key. Wait for all movement
to stop before getting off the seat.
NOTE: A blade/blower brake should normally
stop drive line rotation within five (5) seconds
of disengaging the PTO clutch.
16. For side discharge mower decks, do not op-
erate with the grass deflector shield re-
moved. Keep the deflector in the lowest
possible position.
17. When using the tilt-up deck, observe the
following:
a. Do not move tractor with deck in tilt-up
position.
b. Never tilt seat panel forward with deck in
tilt-up position.
18. Do not operate the machine with the grass
catcher in the DUMP position or with the
back door OPEN. Dangerous projectiles may
be thrown out of the discharge chute or the
back of the grass catcher.
19. Use care when closing the grass catcher
door. Keep fingers and hands away from the
hinge and pinch points when the door is being
closed. Also, keep fingers and hands clear of
the door frame. The door may slam shut with
considerable force.
Use leg muscles and firm footing when lift-
ing the catcher to dump; avoid bending at
the waist and using back muscles in order
to prevent back injury.
CAUTION
20. In case of a clogged or plugged mower
deck or GHS catching system:
a. Disengage the blade clutch (PTO), engage
the parking brake, and turn the engine off
before leaving the seat.
b. LOOK to make sure blade drive shaft and
blower drive pulley movement has stopped
before trying to unclog the system.
c. Disconnect the spark plug wires.
d. Never place hands under the deck or in
the GHS blower - use a stick or similar tool
to remove clogged material.
21. If the cutting blades strike a solid object or the
machine begins to vibrate abnormally, imme-
diately disengage the blade clutch (PTO),
engage the parking brake, stop the engine,
and wait for all moving parts to stop. To
prevent accidental starting, disconnect the
spark plug wires. Thoroughly inspect the
mower and repair any damage before restart-
ing the engine and operating the mower.
Make sure cutter blades are in good condition
and blade nuts are torqued to 60 lb·ft (81 N·m)
for gear-driven decks, and blade bolts torqued
to 70 lb·ft (95 N·m) for belt-driven decks.
22. Do not touch the engine or muffler while
the engine is running or immediately after
stop ping the engine. These areas may be hot
enough to cause serious burns.
23. Do not stop or park in or near dry grasses
or bushes when operating the mower. The
heat from the engine or muffler could ignite the
dry material.
24. When leaving the machine unattended, disen-
gage the blade clutch (PTO), engage the
parking brake, stop the engine, and remove
the key.
25. Do not exceed recommended tow capaci-
ties. Do not tow with the PTO clutch or mower
blades engaged, and do not allow people to
ride in or on towed trailers.
26. Use caution when towing on slopes, rough
terrain or when conditions limit traction. Do
not tow on slopes greater than 5 degrees
(9%).
Safety Instructions
13