Table of Contents
Advertisement
en-us Basic settings
14 Basic settings
Basic settings
You can configure the basic settings for your appliance to meet your needs.
Basic settings
14.1 Overview of the basic settings
The basic settings depend on the features of your appliance.
Basic setting
W. hardness
Rinse aid disp.
Sensor setting
Extra Dry
EmotionLight
TimeLight®
1
Factory setting (may vary according to model)
22
Display text
Selection
H:00
1
H:00 - H:07
r:05
1
r:00 - r:06
1
SE:00
SE:00 - SE:02
1
d:00
d:00 - d:01
EL:02
1
EL:00 - EL:02
S:01
1
S:00 - S:01
Description
Set the water softening system to your water
hardness.
→ "Setting the water softening system",
Page 15
Level H:00 switches the water softening
system off.
Set the amount of rinse aid.
→ "Setting the amount of rinse aid", Page 16
Switch the rinse aid system off with level
r:00.
Set the water sensor for identifying soiling.
→ "Sensors", Page 6
The temperature is increased during the final
rinse, which improves the drying result. This
may increase the run time slightly.
Note: Not suitable for delicate items of
dishware.
Switch Extra Dry on "d:01" or off "d:00".
Interior lighting.
¡ With the setting "EL:00", the interior
lighting is switched off.
¡ With the setting "EL:01", the interior
lighting can be activated via the ON/OFF
button.
¡ With the setting "EL:02", the interior
lighting goes on when you open the
appliance door.
When the appliance door is opened, the
interior lighting switches off automatically
after 10 minutes.
Switch TimeLight on or off.
While the wash cycle is running, status
information (delay time, cycle indicator or
time remaining) is projected onto the floor
below the appliance door. If the base panel
is pulled forward or if the appliance is
installed at eye level with the cabinet front
fitted flush, the display is not visible.
Level "S:00" switches TimeLight off.
Advertisement
Table of Contents
