General Description; Functional Description - Caen V895 Series Manual

16 channel leading edge discriminators
Table of Contents

Advertisement

Document type:
Title:
User's Manual (MUT)
Mod. V895 16 Channel Leading Edge Discriminator

General description

1.
1.1.

Functional description

The CAEN Mod. V895 is a 16 CHANNEL LEADING EDGE DISCRIMINATOR housed in
a single width VME module. The module accepts 16 negative inputs (positive on request)
and produces 16 differential ECL outputs with a fan-out of two on two front panel header
connectors (a functional block diagram is shown in Fig. 1.2).
The pulse forming stage of the discriminator produces an output pulse whose width is
adjustable in a range from 5 ns to 40 ns via VME.
Each channel can work both in Updating and Non-Updating mode according to on-board
jumpers position.
The discriminator thresholds are individually settable in a range from -1 mV to -255 mV (1
mV step), via VME through an 8-bit DAC. The front panel houses also VETO and TEST
inputs.
A Current Sum output generates a current proportional to the input multiplicity, i. e. to the
number of channels over threshold, at a rate of -1.0 mA per hit ±20 %.
A "MAJORITY" output provides a NIM signal if the number of input channels over
threshold exceeds the MAJORITY programmed value.
Several V895 boards can be connected in a daisy chain via the Current Sum output: in
this case, by switching the majority logic to "External", it's possible to obtain a Majority
signal when the number of active channels in the chained modules exceeds a global
Majority level.
An "OR" output on a front panel connector provides a global OR of the output channels.
The relevant "OR" LED lights up if at least one of the unmasked channels is over
threshold. The module's operations are completely controlled via software for each
channel through the VME bus. The most important are:
Setting of the discriminator thresholds (8 bit data) from -1 to -255 mV.
-
-
Setting pattern of inhibit; each channel can be turned "ON" or "OFF" by using a mask
register.
Setting output width in a range from 5 to 40 ns.
-
Setting of the Majority threshold value.
-
-
Common TEST.
Several versions are available, refer to Table 1.1 for details.
NPO:
00101/97:V895x.MUTx/03
Filename:
v895_rev3.doc
Revision date:
Revision:
19/03/09
3
Number of pages:
25
Page:
5

Advertisement

Table of Contents
loading

Table of Contents