Cylinderical Brush Model - ICE COBOTICS i-SYNERGY i28BTL+ Operator's & Parts Manual

CYLINDRICAL BRUSH MODEL
INSTALL BRUSH
1. Raise scrub head off the floor and turn off the
power.(remove key)
2. Remove brush door from scrub head by
loosening the knob.
3. Attach brush door to the brush end that has the
double row of bristles to install brush.
4. Check the brushes to ensure they are properly
adjusted.
INSPECT THE BRUSH PATTERN
After installing a new set of cylindrical brushes
check the brush pattern to ensure proper brush
adjustment.
1. Measure the distance from the front edge
of the scrub head to the floor and from the
back edge of the scrub head to the floor.The
measurements should be the same.
2. To level the scrub head, loosen the lock nut and
turn the leveling screw clockwise to lower the
rear of the scrub head or counter--clockwise to
lower the front.
3. Position the machine on a dry dusty floor or
apply a powdered substance, such as chalk.
4. Adjust the speed control knob to "zero"(
5. Shut off the solution flow.
6. Pull the control handle bail to create a brush
pattern on the floor.
7. Raise the scrub head and pull the machine
away.
8. Observe the brush pattern on floor. If the brush
pattern is uneven or tapered, adjustment is
required.
ICE i28BTL / i28BTL-CY / i32BTL
TO ADJUST A TAPPERED BRUSH PATTERN
1. Remove the brush door from the brush.
2. Hold the brush plug shaft with a wrench and
loosen the 6mm hex screw.
3. To lower the brush end, turn the shaft clockwise
for the front brush and counter--clockwise for
the rear brush. Retighten hex screw.
4. Recheck brush pattern.
NOTE: Replace brushes when worn to 5/8"
(15mm).
)
OPERATOR MANUAL
11