Related Manuals for Creative Play PARK BENCH DOUBLE SIDED CP051/PBD
Summary of Contents for Creative Play PARK BENCH DOUBLE SIDED CP051/PBD
- Page 1 PARK BENCH - DOUBLE SIDED Assembly Instructions STANDARD DOUBLE LENGTH VERSION IMPORTANT - If foundation are required support legs will be have been extended 450mm REF: CP051/PBD - PARK BENCH DOUBLE SIDED pg 1 of 8...
-
Page 2: Parts Required
PARTS required BENCH SLATS - QTY 8 (147mm x 47mm) BENCH SLAT FRONT - QTY 2 (147mm x 47mm) TOP TRIM - QTY 1 (147mm x 47mm) ARM RESTS - QTY 2 (147mm x 47mm) *IMPORTANT - if foundations required additional 450mm included If freestanding use angle cleats and expansion bolts/excalibur bolts to secure seats onto tarmac BENCH SUPPORT (BACK) - QTY 2... -
Page 3: Tools Required
PARTS required continued... BENCH SLAT SUPPORTS - QTY 2 (90mm x 90mm) (180mm brass screws) (120mm brass screws) (80mm brass screws) OPTIONAL - If installed onto tarmac/concrete NOT REQUIRED IF SUPPORT POSTS HAVE BEEN EXENDED FOR FOUNDATIONS (angle cleats/brackets) (40mm brass screws) expansion bolts / excalibur bolts To be used to secrure seats onto tarmac TOOLS required... -
Page 4: Foundation Details
Foundation Details SOIL TIMBER SUPPORT POST CONCRETE pg 4 of 8 REF: CP051/PBD - PARK BENCH DOUBLE SIDED... - Page 5 Assembly Instructions If the bench IS pre-assembled JUMP TO STEP Position the T5, T6 & T7 timbers Using 180mm brass screws *Ensure screws are as shown below Measurement shown is from finsihed ground level - if legs are extended to allow concrete foundations ADD 450mm (TOTAL 763mm) pg 5 of 8 REF: CP051/PBD - PARK BENCH DOUBLE SIDED...
- Page 6 Assembly Instructions Repeat for the second set of T5, T6 & T7 timbers Attach the T1 & T2 timbers to the T7 slat supports Using 120mm brass screws Use 4 screws per SLAT (2 each side) ensure they are uniform Face of T2 and T6 timber FLUSH/LEVEL *5mm gap between the T1 timbers pg 6 of 8...
- Page 7 Assembly Instructions Attach the T4 (arm rests) Using 120mm brass screws & 80mm brass screws 2 x 120mm brass screws 2 x 120mm brass screws 2 x 80mm brass screws *Ensure screws are as shown pg 7 of 8 REF: CP051/PBD - PARK BENCH DOUBLE SIDED...
- Page 8 Assembly Instructions Attach the T1 & T3 timbers to the T5 seat supports Using 120mm brass screws *Lower T1 timber (for back rest) sits on top of the arm rest *5mm gap between the T1 timbers Install the ASSEMBLED BENCH Using ANGLE CLEATS with 40mm brass screws and EXPANSION BOLTS or CONCRETE INTO GROUND as per foundation drawings Follow the FOUNDATION DETAILS on Page 4...
Need help?
Do you have a question about the PARK BENCH DOUBLE SIDED CP051/PBD and is the answer not in the manual?
Questions and answers