Subscribe to Our Youtube Channel
Related Manuals for Creative Play CP008/OCT
Summary of Contents for Creative Play CP008/OCT
- Page 1 5m HALF OCTAGONAL SHELTER Assembly Instructions NO ROOF - Includes floor, internal seating (x 4) and standard sides (x4) REF: CP008/OCT - NO ROOF VERSION pg 1 of 13...
-
Page 2: Parts Required
T4, T5A & T5B not required (angle cleats/brackets) (67.5 degree (concrete slabs) angle bracket) 4 per fence element, 3 per seat (octagonal floor centre cap - deck board) (floor trim pieces) deckboard cut to 40mm pg 2 of 13 REF: CP008/OCT - NO ROOF... - Page 3 & fascia boards to main support beams Additional 16 required for seat slats if not pre-assembled x450 approx. (decking screws) To be used for floor assembly (deck boards) to main support beams pg 3 of 13 REF: CP008/OCT - NO ROOF...
-
Page 4: Tools Required
Overall dimensions & additional shown for installation purposes PLEASE NOTE some images shown are of the 6m NO ROOF and have been used for visual purposes only Any measurements however are specific to the 5m NO ROOF pg 4 of 13 REF: CP008/OCT - NO ROOF... -
Page 5: Foundation Details
Foundation Details pg 5 of 13 REF: CP008/OCT - NO ROOF... - Page 6 Construct the main beam assembly BEFORE adding floor and side assemblies steps Position the T2 timbers All grooved faces will be UP (use a concrete slab in the centre if required) pg 6 of 13 REF: CP008/OCT - NO ROOF...
- Page 7 (90mm x 90mm timber) *The angle bracket is ‘flipped’ meaning the holes remain offset either side of the T2 timber Screw 67.5 degree angle bracket to T3A & T3B Timbers Using 80mm brass screws pg 7 of 13 REF: CP008/OCT - NO ROOF...
- Page 8 Attach the floor assembly to T2 & T3 timbers Using angle cleats / brackets with 80mm brass screws (into T3 timbers) & 120mm brass screw (into T2 timbers) 120mm brass screw pg 8 of 13 REF: CP008/OCT - NO ROOF...
- Page 9 Using 2 deck screws either side of each slat Screw the floor assembly (triangular section) to the T2 timbers Using 2 deck screws either side of each slat Install the OCTAGONAL FLOOR CENTRE CAP pg 9 of 13 REF: CP008/OCT - NO ROOF...
- Page 10 - Ensure the brass screws do not ‘cross’ each other (either side of the post) - STANDARD SIDE suppport beam will finish flush/ level with the top of the T1 timber pg 10 of 13 REF: CP008/OCT - NO ROOF...
- Page 11 Screw the side trim pieces to the standard side supports Using deck screws The back face of the the TRIM PIECE will be flush/in line with the STANDARD SIDE SUPPORT (90mm x 90mm) ST1A ST1B ST1A ST1B pg 11 of 13 REF: CP008/OCT - NO ROOF...
- Page 12 - The seat slats are butted up against each other - If not pre-assembled use 80mm brass screws to secure slats to supports NO ROOF version is available without seating OMIT SEATING IF NOT REQUIRED/ORDERED pg 12 of 13 REF: CP008/OCT - NO ROOF...
- Page 13 Dimensions pg 13 of 13 REF: CP008/OCT - NO ROOF...
Need help?
Do you have a question about the CP008/OCT and is the answer not in the manual?
Questions and answers