Using Your Water Kettle - Faber FCK 110SS Instruction Manual

USING YOUR WATER KETTLE

1. Place the unit on the level surface.
2. To fill the kettle, remove it from the power base and
open the lid by pressing the lid release button, fill
with the desired amount of water, and then close the
lid. Alternatively, the kettle may be filled through the
spout. The water level should not exceed MAX
marks or sit below MIN level. Too little water will
cause the kettle switching off before the water has
boiled.
NOTE: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down
the On/Off switch, the indicator will light up. Then
the kettle will start to boil the water, once the water
has being boiled the On/Off switch will be off
automatically. You can shut off the power by lifting
the On/Off switch at any moment during boiling
water. If you want to boil water again, only press
down the On/Off switch directly to restart the kettle.
6