Before Using Your Kettle; Using Your Water Kettle - Faber FCK DW 2200 Instruction Manual

KNOW YOUR WATER KETTLE

BEFORE USING YOUR KETTLE

If you are using the kettle for the first time, it is recommended that you should clean your
kettle before use by boiling the Max capacity of water once and then discarding the water.
Wipe the surface with damp cloth.
NOTE: The max capacity of kettle is

USING YOUR WATER KETTLE

1. Place the unit on the level surface.
2. To fill the kettle, remove it from the power base and open the lid by pressing the lid
release button, fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should not
exceed MAX marks or sit below MIN level. Too little water will cause the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is firmly in place before plugging the power
outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/Off switch, the indicator will
light up. Then the kettle will start to boil the water, once the water has being boiled the
1.7 L.
5