Crunch GPX600.2 User Manual page 11

FIGURES
(P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Power-/Protection-LED
(2) High pass filter controller
(3) Selector FULL / LPF (Low pass) / HPF (High pass)
(4) Low pass filter controller
(5) Audio signal outputs to supply additional amplifiers
(6) Audio signal inputs
(7) Bass Boost selector
(8) Treble Boost selector
(9) Gain controller
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuse(s)
2-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive 2 loudspeakers, in
stereo connect the following setup:
(1) To the head unit, line output right
(2) To the head unit, line output left
(3) Loudspeaker left
(4) Loudspeaker right
1-CHANNEL OPERATION MONO (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) To the head unit, line output rear right or subwoofer output
(2) To the head unit, line output rear left or subwoofer output
(3) Subwoofer
IMPORTANT!
Always observe the correct polarity of all connections!
11