Operating The Throttle; Operating The Choke; Starting The Engine - Toro 74683 Operator's Manual

Hide thumbs Also See for 74683:
Table of Contents

Advertisement

Operating the Throttle

You can move the throttle control between the F
and S
positions
(Figure
LOW
Always use the F
position when engaging the PTO.
AST
Figure 21

Operating the Choke

Use the choke to start a cold engine.
1.
Push the throttle/choke control past the F
position detent and into the C
engage the choke before using the key switch.
Figure 22
2.
Move the control out of the C
to disengage the choke after the engine has
started.
AST
21).
g296056
AST
position to
HOKE
g369269
position
HOKE

Starting the Engine

Important:
Do not engage the starter for more
than 5 seconds at a time. Engaging the starter
motor for more than 5 seconds can damage the
starter motor. If the engine fails to start, wait 1
minute before operating the engine starter again.
Note:
It may be necessary to hold the lever against
the stop, in the choke position, while trying to start the
engine
(Figure
23).
19
Figure 23
g369267

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter zs 4200s

Table of Contents