Advertisement
Quick Links
MINI BLINDS
Classic
GETTING STARTED
A few simple tools are required:
Steel Tape Measure
Power Drill and
Flathead & Phillips
Drill Bits
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Professional installation is also available in most areas,
call 800-800-3329.
1
| Classic Mini Blinds
Pencil
Level
Awl (or tool for
Screwdriver
starting a screw hole)
STANDARD HARDWARE
End Brackets
(Open Position LH & RH)
Screws
OPTIONAL HARDWARE
Extension Bracket
Phillips Machine
Hex Machine
Screws
Nuts
Top Brackets
Valance Clip
Center Support
Hold Down Brackets
with Screws
Spacers
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for 3 Day Blinds MINI BLINDS Classic
Summary of Contents for 3 Day Blinds MINI BLINDS Classic
- Page 1 MINI BLINDS Classic STANDARD HARDWARE GETTING STARTED A few simple tools are required: End Brackets Top Brackets (Open Position LH & RH) Steel Tape Measure Pencil Level Screws Valance Clip Center Support Power Drill and Flathead & Phillips Awl (or tool for Drill Bits Screwdriver starting a screw hole)
- Page 2 INSIDE MOUNT TO INSTALL CENTER SUPPORT BRACKET(S): • If your hardware packet includes one center support bracket, position • With the blind fully it as close to the center opened, hold it up to wall of the window casing as in the position it will hang.
-
Page 3: Outside Mount
OUTSIDE MOUNT TO INSTALL CENTER SUPPORT BRACKET(S): • If your hardware packet TO INSTALL THE END MOUNTING BRACKETS: includes one center support bracket, position • Unwrap the cellophane from around the blind stack. it as close to the center Caution: DO NOT cut the cellophane as the cords or ladders of the mounting surface supporting the blind may be inadvertently cut. -
Page 4: Blind Installation
VALANCE INSTALLATION BLIND INSTALLATION Make sure the valance clips have been attached to the • If you ordered the blind headrail as noted in "Blind Installation". with a valance, snap the valance clips to the front of the headrail before INSIDE MOUNT VALANCE INSTALLATION installing the blind. -
Page 5: Blind Operation
OPTIONAL HARDWARE BLIND OPERATION INSTALLATION SPACERS To lower the blind, pull the lift cords down and toward the center of the blind and allow the cords to slide slowly through your hand. Spacers Available for use on windows with a To tilt the slats, twist the tilt wand. - Page 6 Repeat for any remaining cords. 800-800-3329 | 3dayblinds.com Part # PM-047 © 3 Day Blinds Corporation 07/17 | Classic Mini Blinds...
Need help?
Do you have a question about the MINI BLINDS Classic and is the answer not in the manual?
Questions and answers