Download
Share
Print this page
  1. Manuals
  2. Brands
  3. 3 Day Blinds Manuals
  4. Window Blinds
  5. Faux Wood 1
  6. Getting started

3 Day Blinds Faux Wood 1 Getting Started

Hide thumbs
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual
1" FAUX WOOD BLINDS
GETTING STARTED
A few simple tools are required:
Steel Tape Measure
Power Drill and
Flathead & Phillips
Drill Bits
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Professional installation is also available in most areas,
call 800-800-3329.
| 1" Faux Wood Blinds
1
Pencil
Level
Awl (or tool for
Screwdriver
starting a screw hole)
STANDARD HARDWARE
End Brackets
(Open Position LH & RH)
Screws
Center Support
OPTIONAL HARDWARE
Hold Down Brackets
with Screws
Glue
Valance Returns
Valance Clips
Spacers
(one spacer
per bracket)
Extension Bracket

Advertisement

loading
Need help?

Need help?

Do you have a question about the Faux Wood 1 and is the answer not in the manual?

Questions and answers

Related Manuals for 3 Day Blinds Faux Wood 1

Summary of Contents for 3 Day Blinds Faux Wood 1

  • Page 1 1" FAUX WOOD BLINDS STANDARD HARDWARE GETTING STARTED A few simple tools are required: End Brackets Valance Clips (Open Position LH & RH) Steel Tape Measure Pencil Level Screws Center Support Power Drill and Flathead & Phillips Awl (or tool for Drill Bits Screwdriver starting a screw hole)
  • Page 2 INSIDE MOUNT TO INSTALL CENTER SUPPORT BRACKET(S): • If your hardware packet includes one center • Mount a bracket in each corner of the window. support bracket, position it as close to the center • Position the front edge of the window casing as of the closed end bracket possible, making sure flush with the front edge...

  • Page 3: Outside Mount

    OUTSIDE MOUNT TO INSTALL CENTER SUPPORT BRACKET(S): • If your hardware packet TO INSTALL THE END MOUNTING BRACKETS: includes one center support bracket, position • Unwrap the cellophane from around the blind stack. it as close to the center Caution: DO NOT cut the cellophane as the cords or ladders of the mounting surface supporting the blind may be inadvertently cut.

  • Page 4: Blind Installation

    BLIND INSTALLATION VALANCE RETURN NOTE: If you did not order valance returns for your blind, • If you ordered the blind proceed to “Valance Installation” below. with a valance, snap the valance clips to the front of the headrail before •...
  • Page 5 OPTIONAL HARDWARE BLIND OPERATION INSTALLATION To lower the blind, pull the lift cords down and toward the SPACERS center of the blind and allow the cords to slide slowly through your hand. Spacers To tilt the slats, twist the tilt wand. Available for use on windows with a (one spacer per projected molding.
  • Page 6 ANSI/WMCA A100.1-2012 5.3.1.1 800-800-3329 | 3dayblinds.com | 1" Faux Wood Blinds Part # PM-031 © 3 Day Blinds Corporation 3/13...