Advertisement
Quick Links
VINYL BLINDS
STANDARD HARDWARE
GETTING STARTED
A few simple tools are required:
Screws
End Brackets
Center Support
(Open Position LH & RH)
Bracket(s)
Level
Steel Tape Measure
Pencil
Flathead & Phillips
Power Drill and
Awl (or tool for starting
Regular Valance Clips
Button Valance Clips
Screwdriver
Drill Bits
a screw hole)
Included in your order is all the hardware necessary for a
normal installation. Depending on the mounting surface,
fasteners other than the screws provided may be required.
Wall board and plaster require the use of anchors such as
expansion or toggle bolts. Bricks, tile and stone need special
plugs and drill bits. Wood should always be pre-drilled to
avoid splitting.
Outside Mount
Inside Mount
Professional installation is also available in most areas,
Slat Valance
Slat Valance
call 800-800-3329.
1
| Vinyl Blinds
Advertisement
Related Manuals for 3 Day Blinds VINYL BLINDS
Summary of Contents for 3 Day Blinds VINYL BLINDS
- Page 1 Bricks, tile and stone need special plugs and drill bits. Wood should always be pre-drilled to avoid splitting. Outside Mount Inside Mount Professional installation is also available in most areas, Slat Valance Slat Valance call 800-800-3329. | Vinyl Blinds...
-
Page 2: Optional Hardware
• Using a flathead screwdriver, open the latches of the end brackets. • Mount the bracket using two of the screws provided. • Repeat this procedure for the right end bracket. | Vinyl Blinds... -
Page 3: Outside Mount
• Using a drill with a " drill bit or an awl, make a small pilot hole at each pencil mark. • Mount the bracket using the 2 screws provided. • Repeat this procedurre for the right end bracket. | Vinyl Blinds... -
Page 4: Blind Installation
• Close the hinges on the end brackets until you hear them “snap.” • While supporting the bottom of the blind, unwind the draw cords and gently lower the blind to its full length. Proceed to “Valance Installation.” | Vinyl Blinds... - Page 5 • Using large scissors, cut the valance returns to the proper length. • To install your two slat valance, start with the shortest of the two slats. This slat will be installed on the lower section of the valance clips. | Vinyl Blinds...
- Page 6 Using the level and a pencil, mark the • Attach valance returns to bottom corners of each extension bracket. the valance using the closed valance corner. • Remove the extension brackets from the valance and install them using the screws provided. | Vinyl Blinds...
- Page 7 • Clip the back of the valance clip onto the headrail. • Repeat this procedure for the other end of the valance. • Allow the glue to dry for at least 10 minutes before installing the valance. Proceed to “Blind Intallation" Proceed to “Valance Clip Installation”. | Vinyl Blinds...
- Page 8 • Close the hinges on the end brackets until you hear them “snap.” • While supporting the bottom of the blind, unwind the draw cords and gently lower the blind to its full length. Proceed to “Valance Installation.” | Vinyl Blinds...
-
Page 9: Blind Operation
• Insert the metal hook into the hole in the shaft. • Slide the plastic sleeve down the shaft and over the tilt wand hook until it is secure. | Vinyl Blinds... - Page 10 • Lower the blind and flex the hold down bracket outward so that the pin can be inserted into the hole in the bottom rail. 800-800-3329 | 3dayblinds.com | Vinyl Blinds Part # PM-026 © 3 Day Blinds Corporation 10/13...