Permanent Iridium Go! Exec Mounting-Bracket Installation - Iridium GO! exec GEINSTKT2201 Installation Manual

Iridium GO! exec Premium Dual Mode Antenna Kit (with GNSS)
Note:
1) When an external antenna is connected, you may still raise the device internal antenna.
If the device's "Power ON/OFF based on antenna lift" is enabled, this action turns the unit on and allows for
transmission over the Iridium network as well as acquiring location information using the connected external
antenna, while lowering the device antenna with the external antenna connected will not switch the device off.
To switch the device off with the external antenna connected, you need to use the power button on the device or
use the device's Settings menu. Alternatively, with the device powered on and the device antenna in lowered
position, unplugging the external antenna will switch the device off.
If the device's Setting "Automatically power on the device on charger connection" is enabled, unplugging the
device power supply will also switch off the device, while plugging the device to a power supply will switch the
device on.
2) Please use provided cable ties to secure the antenna cables to the mounting bracket.
Do not leave power and antenna ports uncovered. Open power cover only for as long as
recharging is required, and open antenna cover only when actively using the external antenna.
Leaving the covers open allows moisture and water vapor to enter the device which in turn
could lead to corrosion and damage to the device. This could cause fire or could cause the
device to fail so that it is unavailable in an emergency situation, preventing or delaying an
emergency response. These hazards could cause serious injury or death.

3 Permanent Iridium GO! exec Mounting-Bracket Installation

Step 1:
(A) Choose the preferred location (on a boat) where
you want to permanently mount the cradle for
holding the Iridium GO! exec.
Please make sure the selected location is within
the range of the satellite cable and GNSS cable.
(B) On the horizonal surface or vertical surface at the
selected location, drill the 4 pilot holes which align
with the four holes on the 1"-ball-square base.
(C) Align the 1"-ball-square base on top of the 4 pilot
holes and fasten with the four screws.
Step 2:
(A) Loosen knob on double socket arm and remove the
Suction Cup Twist Lock Base.
(B) Attach the double socket arm to the 1"-ball-square
base in step 1.
9