Tools Needed; Hardware Provided - Koala Kare KB200-SS Installation And Operation Instruction Manual

KB200-SS Operating Instructions
Please Note: To assure proper installation, it is suggested that a qualified person or carpenter install
the Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not
installed properly.
Koala Baby Changing Stations have been tested to hold a substantial static load. The unit must be
attached to a permanent wall that is capable of holding a substantial load.
Inspection Criteria:
A properly maintained baby changing station:
• Opens and closes smoothly
• Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
• Provides a clean, convenient place for customers to attend to their children.

Tools Needed

measuring
gloves safety glasses
drill pencil stud finder level
tape
1/8" (3 mm) Phillips head 7/32" (6 mm) ½" (13 mm)
(regular masonry) screwdriver (regular masonry) (regular masonry)
& & &
drill bits drill bits drill bits

Hardware Provided

six ¼" x 3" Phillips four 8-32" x 5/16" flange
four ¼" flat washers
panhead wood screws button Phillips head screws