OPERATING INSTRUCTIONS
Please Note:
To assure proper installation, it is suggested that a qualified person or carpenter install the
Koala Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed
properly. Koala Baby Changing Stations have been tested to hold a substantial static load. The unit
must be attached to a permanent wall that is capable of holding a substantial load. The maximum
recommended total weight for this baby changing station (including baby and parcel bag) is 60 lbs.
Excessive weight may cause a hazardous or unstable condition to exist.
Using Restraint System
To fasten the waist restraint strap, place strap around child's midsection, and push spring tabs into
buckle until both spring tabs lock in place with an audible "click". Straps can be adjusted to make strap
tighter or looser as required.
Inspection Criteria:
A properly maintained baby changing station:
– Opens and closes smoothly.
– Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached at
both ends of the unit.
– Offers parents liners through a fully stocked liner dispenser. (Dispenser is built into unit.)
– Provides a clean, convenient place for customers to attend to their children.
Measuring
Tape
Gloves
Drill
Four 1/4"x 3" Phillips Panhead Wood
Screws
1
TOOLS NEEDED
Phillips Head
Screwdriver
1/8" Drill Bit
(regular)
HARDWARE PROVIDED
Level
7/32" Drill Bit
(masonry)
Four
Flat Washers
¾" x ¼"
Stud
Finder
Pencil
1/2" Drill Bit
(regular and
masonry)