Bosch TDL 110 Manual page 2

Quick Start Guide
A full description is available at: www.bosch-connectivity.com/TDL110
Connection to TDL (Figure 1):
1. Start the Data Logging App. You will find the App "Bosch Transport
Data Logger" in your Apple App Store or Google Play Store for free.
2. Activate Bluetooth on your smartphone.
3. To activate the TDL press the button on the device from 0.3 to
1.5 seconds.
4. To find the activated TDL tap "Search".
5. Choose your desired TDL.
Configure the TDL (Figure 2):
To configure your app follow the steps shown in the app (e-mail
(option) for data transfer, device name, PIN, logging parameter).
No TDL Access!
Notice
You cannot configure the TDL without a valid PIN. It is impossible to reset
the PIN; even at the factory.
EN
▶ Always make a note of the PIN and store it on a safe place.
Convention for Characters
Notice
For e-mail and device name only defined characters are usable.
▶ These characters are allowed: a–Z", 0–9, and @ . , ; / \| + - * _
To start logging immediately tap "Start logging and disconnect". To
start logging later tap "Disconnect" in the app and then press the
button on the TDL. The TDL blinks three times green to confirm that
logging has started.
Data Transfer (Figure 3)
Connect your smartphone with the configured TDL. Follow the steps
in the app to display and download the desired data.
Lithium Battery!
Caution
The device contains a lithium battery. Handling the battery incorrectly could
cause a fire.
▶ Use only original or approved batteries.
▶ Read and follow the valid transportation regulations, if necessary.
Forfeiting the Warranty!
Notice
Opening the casing without authorization could present risks to the user and
will void any warranty.
▶ Do not open the housing.
▶ Use only original or approved accessories.
Disposal according to the WEEE Directive 2012/19/EU
The unit, accessories and packaging should be sorted for
environmental-friendly recycling. Do not dispose of the de-
vice into household waste! According to the European Guide-
line 2012/19/EU, electric and electronic devices that are no longer
usable must be collected separately and disposed of in an environ-
mentally correct manner.
Declaration of conformity:
Hereby, Bosch Connected Devices and Solutions GmbH declares that
the radio equipment type "Transport Data Logger TDL 110" is in
compliance with Directive 1999/5/EG. The full text of the EU declara-
tion of conformity is available at the following internet address:
www.bosch-connectivity.com/TDL110
Federal Communications Commission (FCC) Notice
This device complies with Part 15 of the FCC Rules. Operation is sub-
ject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
The manufacturer is not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. Such
modifications may void the FCC authorization to operate this equip-
ment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These li-
mits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
Transport Data Logger TDL 110
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
▶ Reorient or relocate the receiving antenna.
▶ Increase the separation between the equipment and receiver.
▶ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
▶ Consult the dealer or an experienced radio/TV technician for help.
Industry Canada (IC) Notice
This device complies with Industry Canada license-exempt RSS stan-
dard(s). Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any
interference, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L 'exploitation est autorisée aux deux
conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
.