Bosch AKE 40-19 PRO Original Instructions Manual page 21

OBJ_BUCH-2379-001.book Page 21 Thursday, March 2, 2017 1:02 PM
Chain saw
Run down brake
Weight according to EPTA-Procedure 01:2014
Protection class
***measured with chain bar and chain
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Starting cycles generate brief voltage drops. Interference with other equipment/machines may occur in case of unfavourable mains system conditions.
Malfunctions are not to be expected for system impedances below 0.25 ohm.
Noise/Vibration Information
Sound emission values determined according to
EN 60745-2-13.
Typically the A-weighted noise levels of the product are:
Sound pressure level 95 dB(A); sound power level
103 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-13:
2 2
a =8 m/s , K=1.5 m/s .
h
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Assembly
For Your Safety
 Warning! Switch off, remove plug from mains before
adjusting cleaning or if the cable is cut, damaged or en-
tangled.
 Caution! Do not touch the rotating chain.
 Do not operate the chain saw near other people, chil-
dren or animals. Do not operate the chain saw after
drinking alcohol or under the influence of intoxicating
drugs or medication.
Bosch Power Tools
AKE 35-19 PRO
kg
Electrical Safety
Your power tool is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz
(for non-EU countries 220 V, 240 V as applicable). Only use
approved extension cables. Contact your Bosch Service Cen-
tre for details.
Only extension cables of design type H07 RN-F or IEC (60245
IEC 66) are permitted for use.
When operating the chain saw with an extension cable, the
following conductor cross-sections are required:
2
– 1.0 mm : max. length 40 m
2
– 1.5 mm : max. length 60 m
2
– 2.5 mm : max. length 100 m
It is recommended for increased electrical safety to use a Re-
sidual Current Device (RCD) with a tripping current of not
more than 30 mA. Always check your RCD every time you use
it.
For products not sold in GB:
WARNING: For your safety, it is required that the plug 24 at-
tached to the machine is connected with the extension cord
25 as shown. The coupling of the extension cord must be pro-
tected against splash water, be made of rubber or coated with
rubber. The extension cord must be used with a cable strain
relief.
The connection lead must be inspected for signs of damage at
regular intervals and may only be used if in perfect condition.
If the supply cable on the product is damaged, it must only be
replaced by a Bosch Service Centre.
Mounting and Tensioning the Chain
Saw
 Do not connect the chain saw to mains before it is com-
pletely assembled.
 Always wear protective gloves when handling the
chain.
Chain and Chain Bar Assembly (see figure A)
 Use only chains with a drive link thickness of 1,3 mm.
– Unpack all parts carefully.
– Align the 2 arrows on the chain-tensioning ring 13 and the
cover 15 ( ).
English | 21
AKE 40-19 PRO
 
4.6 4.7
/II /II
F 016 L81 137 | (2.3.17)