Advertisement
MSM313-R Integrated Services Access Point Quickstart
Package contents
MSM313-R featuring a die-cast aluminum enclosure with three-point silicone gasket, two
2.4-GHz (5.5-dBi) 802.11b/g omnidirectional antennas, weatherproof quick-disconnect
RJ-45 Ethernet connector, wall-mount bracket, pole-mount bracket assembly, grounding lug.
The MSM313-R ships fully assembled and ready to operate.
Radios and antennas
The MSM313-R has a single radio with two antennas. The antenna connectors are
weatherproof straight-polarity N-type female bulkhead antenna connectors.
Ethernet port
The MSM313-R has a single 10/100 Mbps Ethernet port with weatherproof RJ-45 connector.
The MSM313-R is a ruggedized version of the MSM313 and shares the same
Note:
feature set. However, due to its weather-proof enclosure: the LAN port, the serial
port, the reset button, and the status lights are not available. The MSM313-R
provides access to the Internet port only and this port has been configured to
support PoE. When using the management tool, ignore references to the LAN port.
For details on resetting the MSM313-R to its factory defaults, see "Resetting to
factory defaults" in the MSC-3000 Series Admin Guide.
Installation
PROFESSIONAL INSTALLATION REQUIRED: Prior to installing or using
WARNING:
this device, consult with a professional installer trained in RF
installation and knowledgeable in local regulations including building
and wiring codes, safety, channel, power, indoor/outdoor restrictions,
and license requirements for the intended country. It is the responsibility
of the end user to ensure that installation and use comply with local
safety and radio regulations.
•
Surge protection and grounding: When connecting an outdoor antenna to the unit make
sure that proper lightning surge protection and grounding precautions are taken
according to local electrical code. Failure to do so may result in personal injury, fire,
equipment damage, or a voided warranty. The HP ProCurve hardware warranty provides
no protection against damage caused by static discharge or a lightning strike.
•
Cabling: You must use the appropriate cables, and where applicable, surge protection,
for your given region. For compliance with EN55022 Class-B emissions requirements
use shielded Ethernet cables.
•
Country of use: Some versions of the unit require the installer to select the appropriate
country during the initial set up. Once the country has been set, the unit will
automatically limit the available channels, ensuring compliant operation in the selected
country. Incorrectly entering the country may result in illegal operation and may cause
harmful interference to other systems.
2
Safety
Take note of the following safety information during installation:
•
If your network covers an area served by more than one power distribution system, be
sure all safety grounds are securely interconnected.
•
Network cables may occasionally be subject to hazardous transient voltages (caused by
lightning or disturbances in the electrical power grid).
•
Handle exposed metal components of the network with caution.
•
This product does not have a power switch. It is powered-on when it is connected to a
PoE power source.
Protection equipment needed
In addition to the items supplied with the MSM313-R, protection equipment will be required
according to your electrical code. For example:
•
Antenna surge suppressor: HP ProCurve Antenna Lightning Arrester, part number
J8996A.
•
Ethernet surge suppressor: Weatherproof PoE compatible 10/100 base-T CAT5
Lightning Protector.
Installation guidelines
The MSM313-R is typically interconnected with other equipment as follows (only the
antennas and weatherproof RJ-45 connector are supplied with the MSM313-R):
Installation procedure
This is a general procedure. It is the installer's responsibility to perform
WARNING:
all installation according to local electrical code and regulations.
Corrosive damage caused by salt fog is not covered by the warranty.
WARNING:
HP ProCurve Networking
Advertisement
