Advertisement
ASSEMBLY
T-Handle Lock Assembly:
Insert T-handle shaft into the pre-drilled hole on the wood panel, leaving 1/4"space outside. Then
●
from the back of the panel, tighten the M10 nut (not the Locknut) first, then put the tongue in, make sure the
tongue is in the same direction of the T-handle, fix the washer and M10 Locknut and tighten them.
When using the lock, please remember that you need to push in the 1/4" gap first before you turn
●
the T-handle. Clockwise is close, counter clockwise is open.
Open
Now the assembly is finished.
Front
Close
20
Back
Close
Open
Advertisement
