Network - EnGenius EPI-9701 User Manual

EUB9701/9702 and EPI-9701series --IEEE802.11b/g/n Wireless LAN Client Adapter
Click on the OK button to save the changes.

3.5 Network

The Network tab displays the current status of the wireless radio. The following
information is included in this tab, as the image depicts below.
Status: This indicates the state of the client. There are three options:
o Associated: Indicates that the wireless client is connected to an
o Scanning: Indicates that the wireless client is searching for an AP
o Disconnected: Indicates that there are no APs or clients in the
Extra Info: Displayed here are information about the link stats and the
percent of output power.
Channel: The operating frequency channel that the client is using
(infrastructure mode).
Authentication: Displays the authentication type.
Encryption: Displays the encryption type.
Network Type: Displays the network type; infrastructure or ad-hoc.
IP Address: Displays the IP address.
Sub Mask: Displays the subnet mask IP address.
Default Gateway: Displays the IP address of the default gateway.
Link Speed: The current rate at which the client is transmitting and
receiving.
Transmit/ReceiveThroughput: Displays the Tx (transmit) and Rx
(receive) kilo-bytes per second.
Link Quality: In infrastructure mode, this bar displays the transmission
quality between an AP and a client. In Ad-hoc mode, this bar displays
the transmission quality between one client, and another.
Signal Strength: This bar displays the strength of the signal received
from an AP or client.
Noise Level: Displays the background noise level; a lower level
Access Point (AP). The BSSID is shown in the form of 12 HEX
digits, which is the MAC address of the AP.
in the area.
area.
Version 1.0
33