Fimco LSS-280-EH Owner's Manual

(200 Gallon Lawn Service Skid Sprayer w/160cc HONDA Engine)
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your Skid
Sprayer.
Retain a copy of your receipt for your unit,
as it will be required to validate any warranty service
Products are warranted against manufacturer or workmanship
defects for one year from date of purchase for home owner
usage and 90 days for commercial usage.
For technical assistance, visit our website @
www.fimcoindustries.com or call: TOLL FREE @ 1-800-831-0027
Our Technical Support Representatives will be happy to help you.
To obtain prompt, efficient service, always remember to give the
following information...

Correct Part Description and/or part number

Model #/Serial # of your sprayer
Part descriptions and numbers can be obtained from the illustrated
parts list section(s) of this manual.
OWNER'S MANUAL
Model: LSS-280-EH (5301867)
Technical Specifications

200 Gallon Polyethylene Tank

160cc Honda Engine w/6:1 Gear Reduction

8 Roller Cast Iron Pump - 10 GPM @ 250 PSI

Pressure Relief Valve

Electric Hose Reel w/Controls

Handgun w/1/2" x 300' of Hose

Delta Jet Agitation
Caution: When fully filled with water, this sprayer will
weigh approx. 2,065 lbs..
Consult the owner's manual for your vehicle to verify
that you are within it's load carrying capacity.
Information About the Sprayer
Roller pumps are positive displacement pumps, which means
that the entire solution being pumped must go somewhere or
the pump will break. In this roller pumping system, solution is
drawn from the tank and forced to a planned source, such a
handgun. The pressure is controlled by a pressure relief valve,
which is a spring-loaded device that controls the amount of
fluid bypassed (recirculated) to the tank. The gray adjusting
cap is to be tightened to increase pressure and loosened to
decrease pressure.
NOTE:
Add proper oil to the engine crankcase and gasoline to the
gas tank. Always check the oil in the gear box. Remove the
plug on the side, oil should be visible. Add oil through the top
plug. Refer to the engine manual for the correct type and
amount.
It is important to test the sprayer with plain water before actual
spraying is attempted. This will enable you to check the spray-
er for leaks in the plumbing system.
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5008114 (12/18)]
Page 1