Fimco LSS-240 Owner's Manual

(200 Gallon Lawn Service Skid-Mounted High Pressure Sprayer)
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON, PLEASE CALL
1-800-831-0027
MONDAY-FRIDAY, 8:00 AM TO 5:00 PM CST
If you should have a question or experience a problem with
your Fimco Industries Product: Visit our website @
www.fimcoindustries.com or call the Toll free number above. Our
technical support representatives will be happy to help you.
In most cases a customer service rep. can resolve
the problem over the phone.
To obtain prompt, efficient service, always remember to give the
following information....
• Correct Part Description and/or part number
• Model number and Serial Number
Part descriptions and numbers can be obtained from the
illustrated parts list section(s) of this manual.
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your
skid sprayer.
Retain a copy of your receipt for your unit, as it will be required
to validate any warranty service.
Warranted against manufacturer or workmanship defects from
date of purchase with copy of receipt:
Homeowner Usage: One Year
Commercial Usage: 90 Days.
OWNER'S MANUAL
Model: LSS-240 (5301259)
Technical Specifications

200 Gallon Polyethylene Tank

Maximum Flow = 10.6 GPM

Maximum Pressure = 580 PSI

Maximum Temperature = 140°F

High Pressure Spray Gun w/1/2" x 300' of Hose

Banjo Garden Hose Spray Nozzle

Delta Jet Agitator
Caution: When fully filled with water, this sprayer will
weigh approx. 2,070 lbs..
Consult the owner's manual for your vehicle to verify
that you are within it's load carrying capacity.
Before Operating the Sprayer
1. Add proper oil to the engine crankcase and gasoline to
the gas tank. Always check the oil in the gear box. Refer
to engine manual for correct oil type. Add SAE 30 to the
sight level in the diaphragm pump. Fill the gear case with
90W gear lube until the gear lube runs out the side plug
hole.
2. Add plain water to the tank and check the system for
leaks. Open the suction line valve. Open the lever valves
by the pressure regulator that are connected to the hand-
gun line and jet agitator line.
3. The pumping system includes an agitator, which will help
keep the solution in suspension. Pressure to the agitator
should never exceed 100 PSI. When spraying at pres-
sures over 100 PSI, use the valve (in the agitator line) to
throttle the pressure to the agitator by closing the valve.
The valve may be opened slowly until the gauge reaches
100 PSI.
Do not exceed recommended pressure on pump or
sprayer, as it may cause hoses to burst and will shorten
pump life.
***WARNING***
This product when used can be dangerous and can cause
bodily harm, only if not properly used or guarded.
* STAY AWAY FROM EQUIPMENT
WHEN IT IS IN OPERATION *
Read information and the full instructions furnished with the
before installing and operating.
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[5004575
product
(12/20)]
Page 1