Insert The Batteries; Remote Control Range Information; Pairing The Remote Control - Hisense 55U6K Quick Setup Manual

Insert the batteries

1. Take off the back cover to open the battery compartment of the remote control.
2. Insert two AA or AAA (1.5Vcc) size batteries. Make sure to match the (+) and (-)
ends of the batteries with the (+) and (-) ends indicated in the battery compartment.
3. Restore the battery compartment cover.
Important information about the remote and batteries
• Discard batteries in a designated disposal area. Do not throw them into a fire.
• Remove old batteries immediately to prevent them from leaking into the battery
compartment.
• If you do not intend to use the remote control for a long time, then remove the
batteries.
• Battery chemicals can cause a rash. If the batteries leak, clean the battery
compartment with a cloth. If chemicals touch your skin then wash it immediately.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (NiCd, NiMH, etc.)
batteries.
• Do not continue using the remote if it gets warm or hot.
• Call our Support Center immediately on the support website.

Remote control range information

• The remote control can work at a distance of up to 26 feet (792.5 cm) in front of the TV set.
• It can work at a 30 degree horizontal or vertical angle.

Pairing the remote control

1. Pair the remote to the TV after you power it on for the first time, there will be
instructions on how to pair the remote.
2. If your remote fails to pair with TV, keep the remote within 10 feet (304.8 cm) from
the TV, press and hold the [
seconds to start pairing.
3. If the remote pairs successfully, a confirmation will display on the screen. If it does
not pair successfully, an unsuccessful message will display. Repeat step 2, or you
can press [
to On.
NOTE:
• If an unknown error occurs with the remote, it could have been caused by
interference. Try to remove what's causing the interference and pair the remote
again.
• If an unknown error occurs with the remote control while the battery power is
normal, you can take out the batteries and press any key for 1~2 seconds, and
insert them back. The remote control can work normally.
• The remote cannot be paired to the TV while the TV is in the standby mode.
] button and [
] button to select Settings > Remotes & Accessories > Bluetooth
] button at the same time at least 3
8