EXPLANATION OF TERMS AND SYMBOLS The term “WARNING!” indicates instructions regarding personal safety. If the instructions are not followed the result may be bodily injury or death. The term “CAUTION!” indicates instructions regarding possible damage to physical equipment. If these instructions are not followed, it may result in damage to the equipment that may not be covered under the warranty.
IMPORTANT!: 802.3bt Type 3 Class 5 (45W from PSE, 40W at NV-21-HU) power input required or 12 VDC 9A power supply required. For more information, see "Power Requirements" on page 5.
Page 4
RoHS Statements The QSC Q-SYS NV-21-HU is in compliance with European RoHS Directive. The QSC Q-SYS NV-21-HU is in compliance with “China RoHS” directives. The following table is provided for product use in China and its territories. QSC Q-SYS NV-21-HU 部件名称...
TD-001652 Introduction The Q-SYS NV Series NV-21-HU is the next evolution for native video distribution on the Q-SYS Platform. The NV-21-HU is a software configurable endpoint offering a comprehensive single-cable solution for video distribution, AV bridging, and device charging via USB-C.
Page 6
4. RS232 – Serial Transmit and Receive. Uses the black 3-pin Euro connector. 5. Reset Button – Use a paper clip, or similar tool, to press and hold the reset button for 10 seconds to reset the NV-21-HU to factory values.
Installation The NV-21-HU can be mounted under a table or desk, on a rack shelf, flush-mounted (such as on a wall), or simply be placed freestanding on a surface without mounting. Regardless of your chosen installation method, you must observe the Ventilation Requirements.
Page 8
Installation Cont'd Under Table Mounting Use the two (2) included brackets and four (4) Phillips pan head screws. Brackets can be attached to the unit either outward-facing or inward-facing, as shown. Screw and anchor hardware for mounting the brackets to the surface is pictured but not included. TIP: If a semi-permanent installation is desired, use the bracket keystone holes in conjunction with screws tightened loosely to the brackets to allow for easy slide-on and slide-off of the unit.
Installation Cont'd Flush / Wall Mounting Use the two (2) included brackets and four (4) Phillips pan head screws. Screws for mounting the brackets to the surface are pictured but not included. Freestanding Installation Attach the four (4) included foam spacers to the underside of the unit.