Troubleshooting - Panasonic nanoe EH-NA9K Operating Instructions Manual

Troubleshooting

Problem Possible cause
Sparks can be
seen inside the
appliance when
using [HOT].
Dust is attached
(These sparks
to the air
are caused by
inlet or air outlet.
the thermostat
switch, the
protective device,
and this is not
Hair or
dangerous.)
something is
blocking the air
Hot air repeatedly
inlet.
turns into cold air.
The hot air is
abnormally hot.
The power plug
The power plug is is not firmly
abnormally hot. inserted into the
outlet.
Sparks are
generated inside
The needle-
the nanoe™
shaped part
outlet.
located at the
back of the
A noise
nanoe™ outlet is
(crackling) is
dirty.
heard inside the
nanoe™ outlet.
14
EH-NA9K 香港向1222.indb 14
Problem
Action
There is a
peculiar smell.
Remove the
attached dust.
(See page
13.)
Water droplets
fly out from the
nanoe™ outlet.
Do not block
the air inlet.
The [HOT]
lamp is blinking
quickly (twice per
second)
Use an outlet
in which the
If the problems still cannot be solved, contact the store
power plug fits
where you purchased the appliance or a service center
snugly.
authorised by Panasonic for repair.
Perform
maintenance
on the nanoe™
outlet. (See
page 13.)
Possible cause Action
This is because
nanoe™ and
mineral ion
produce a
This is normal.
peculiar smell;
there is no
influence to your
body.
Water droplets
occasionally fly
out from when
generating This is normal.
nanoe™;
this is not an
abnormality.
Please consult
Device an authorized
abnormality. service center
for repairc.
2023/1/3 16:34:07