Advertisement
About this task
Important:
You can accomplish most service actions when the node is fully extended from the
rack on its slide rails.
To remove an AC2 enclosure from the rack, complete these steps:
Note: Make sure that you have two people when you lift the server; position their
hands as shown in Figure 1.
Procedure
1. Pull back the cable-management arm if you are working from the rear of the
2. Disconnect and label all cable connections to the enclosure back panel.
3. Pull the locking levers 1 forward, as shown in Figure 1.
4. Support the rear of the server, and lift the front of the server up slightly 2 to
Figure 1. Removing the AC2 from the rack
5. Lift the rear 1 of the server to level the server after the front nailheads clear
6. Lift the server out of the rack 2 and place it on a sturdy surface.
4
FlashCore Forever: Hardware Installation Guide
rack, or slide the node out of the rack to the fully extended rail position if you
are working from the front.
clear the nailhead 3 from the slot.
1
2
Lift point
the latches, as shown in the following figure.
3
Lift point
Advertisement
