Table of Contents
Advertisement
DRAWER AND DOOR
IMPORTANT: Do not allow excess water or cleaner to enter
any holes or slots in the door.
TO CLEAN OVEN DOOR
1 Clean the door and drawer frequently to remove dust, spatters
and fingerprints. Wipe door surfaces with a slightly damp,
non-abrasive cloth, using mild soap and water.
2 For burned-on residue on interior door glass, use a glass
cleaning compound and/or a razor scraper.
3 Clean enameled portions of the door interior with a non-
abrasive sponge and soapy water.
4 Clean exposed metal portions with stainless-steel cleaner
to remove streaks.
The oven door can be removed for easier cleaning, servicing
or installation.
WARNING
FIRE HAZARD
• When reinstalling the oven door, confirm it operates and
seals correctly. Heat escaping from around the door could
ignite cabinetry if the door gasket does not seal completely.
• If the gasket is worn, frayed or damaged in any way, contact
a qualified service provider for repair. To maintain proper
door seal, do not rub or clean the door gasket, as it has a very
low resistance to abrasion.
TO REMOVE OVEN DOOR
1 Open the door fully.
2 On both door hinges, flip down the lock mechanism. The
lock will engage with the door when the door is moved as
if it is being closed.
3 Rotate the door toward closed position, stopping when the
door is about 2 inches from closed position.
4 Grasp the door firmly from both sides and lift the door up and
away from the oven face. Do not lift the door by the handle.
CLEANING AND MAINTENANCE
TO REPLACE OVEN DOOR
1 Holding the door firmly from both sides, align the door to
the oven so the hinges slip back into the openings.
2 Rotate the door toward closed position, stopping when the
door is about 2 inches from closed position. Allow the door
to drop into the notches on the hinges.
3 Rotate the door until fully open and flip up the locking
mechanism.
4 Ensure the door opens and closes correctly and is sealed
properly. If the door does not operate correctly, remove the
door and reattempt installation or contact a qualified service
provider.
TO REMOVE DRAWER
It is not necessary to remove the drawer for cleaning, but if
desired, it can be.
1 Fully extend the drawer.
2 Engage the release levers on each side while gently pulling
on the drawer.
TO REPLACE DRAWER
1 Align the rails on the drawer with the slides on the range.
2 Gently push the drawer into place until fully closed. Open
and close the drawer to ensure slide rails operate properly.
25
E
Advertisement
Table of Contents
