Table of Contents
Advertisement
ACARD AEC-6280
4.1.4 Windows 2000 Environment
Driver installation is required when it is the first time to setup Windows
2000 into the System
For Boot Device
AEC6280.SYS is designed for Microsoft Windows 2000 miniport drivers.
It allows driver connected to IDE devices (which support by Microsoft)
1. Insert Windows 2000 boot disk and boot from floppy disk.
(If boot from CD-ROM or install from hard disk, please press
"F6" for the first booting screen)
2. Follow the Windows 2000 setup procedures.
3. Press "S" to specify additional SCSI adapter.
4. Move the highlight bar to "the other" and press "Enter".
5. Before the installation, copy the AEC-6280's driver into a floppy diskette
first. Then insert the ACARD AEC-6280 driver disk into the floppy.
6. The ACARD Miniport driver should be highlighted at this stage. Press
"Enter" to proceed.
7. Windows 2000 should now recognize the ACARD Miniport driver and
the IDE hardware. Please follow the Microsoft Windows 2000
installation.
Install Driver for Windows 2000
After Windows 2000 has been installed, you may wish to plug the ACARD
AEC-6280 device on the Windows 2000 system. Before plug in AEC-6280,
follow the procedures to install driver manually.
23
Advertisement
Table of Contents
