Logging in
To log in to the access point:
1 Connect the access point to your PoE+ switch or injector with an Ethernet cable.
2 Log in to your Pakedge router to find the IP address assigned to the access point
under the DHCP Client Table.
Tip:
If you do not have a router in your network that distributes IP addresses, you
can try to access the access point through its default IP address of 192.168.1.21.
3 Enter that IP address into a web browser to open the access point interface. The
Sign In page opens.
Note:
Because the AP uses self-signed certificates for secure connection to the
web browser, a security message will appear. There is no risk in proceeding to the
AP's web interface, and communications will remain secure.
4 In the username box, type admin. In the password box, type password, then click
Sign In. The first time you log in, the Configure page opens.
8
8