Download Print this page

Unitech HT330 Quick Start Manual

Hide thumbs Also See for HT330:

Advertisement

Quick Links

HT330
手持式数据采集器
Quick Start Guide
快速设定手册
Product View产品功能说明
1
2
3
4
5
6
7
8
9
1.Scanner Window
扫描视窗
2.LED Indicator状态指示灯
3.5MP Front Camera前镜头
4.4"LCD Display显示屏
5.Volume Key音量键
6.Scanner Trigger Key扫描键
7.Power Key电源键
8.Function Key功能键
9.Mic麦克风
609356G V1.1
10
13
11
14
12
15
16
17
18
10.13MP Rear Camera后镜头
11. Mic麦克风
12. Battery Lock电池锁
13. Speaker扬声器
14. POGO Pin for Gun Grip
15.Holes for Hand Strap手握带
16.Battery Cover电池背盖
17. POGO Pin
18. USB Type-C Port
Package产品内容物
HT330包装含有以下品项,如有任何东西遗失或损坏,请
与unitech精联电子人员联系。
标准包装内容
• HT330 Terminal/HT330主机
• Battery/电池
• Hand Strap/手握带
• USB Type-C Cable/USB Type-C线
• Quick Start Guide/快速设定手册
选配包装配件
• Boot Case/背夹
• Gun Grip/枪把
• Terminal Power Adaptor/电源适配器
• HT330 1-Slot Charging Cradle with spare Battery Slot
/单槽充电底座
• HT330 1-Slot USB Cradle with spare Battery Slot
/单槽USB充电传输座
• Power Cord for Cradle/支架电源线
• Glass Screen Protector/高硬度屏幕保护贴
• Stylus with coil strap/触笔
Keypad View键盘功能说明
WARNING!
There is a risk of fire and burns if the battery is handled improperly.
DO NOT disassemble, crush, puncture, short external contacts, or
dispose the battery pack in fire or water.
DO NOT attempt to open or service the battery. Dispose of used
batteries according to local recycling guidelines in your area.
CAUTION!
To ensure the unit working properly, please keep all connectors away
from the contaminants staying inside of them such as dust, grease, mud,
and water.
The negligence may cause the unit with no communication, short circuited,
overheated and so on. If the connector is damaged, please ensure the
connector is being fully repaired before using the unit to avoid causing
short circuited.
Copyright 2022 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
http://www.ute.com/cn

Advertisement

loading

Summary of Contents for Unitech HT330

  • Page 1 • Quick Start Guide/快速设定手册 选配包装配件 • Boot Case/背夹 • Gun Grip/枪把 • Terminal Power Adaptor/电源适配器 • HT330 1-Slot Charging Cradle with spare Battery Slot /单槽充电底座 • HT330 1-Slot USB Cradle with spare Battery Slot /单槽USB充电传输座 Quick Start Guide • Power Cord for Cradle/支架电源线...
  • Page 2 翻转打开 安装电池盖 按下图所示方向插入电池盖: 1. 电池盖底部有三个挂钩,将挂钩与电池盒上的 凹槽对齐。 按下电池以固定到位。 LED指示灯对照 从下到上以45度角插入电池盖。 LED 光线 描述 .充电中 绿光 红光 . 闪烁时表示电量小于15% . 充电完成 绿光 按下电池盖以固定到位。确保设备和电池盖之间没有 . 此时扫描效果佳 间隙。 蓝光 .讯息提醒 将电池锁向左推 以锁定。确保电池盖牢 如果正在进行扫描,则由扫描模式控制LED。电池没电时,则无 固关闭,否则可能无法打开设备。 显示红光或绿光。 为电池充电 在首次使用终端之前,您需要为其充电约24小时。对 移出电池 于常规使用,您可为终端充电4.5小时,使电池达到 最大容量。要给终端充电,请用USB充电线或底座。 从底部取出电池,然后提起将其卸下。 将Type-C连接到HT330上的USB端口,USB线的另一端 连接到电源适配器,插入USB插头上的电源插座。 当HT330处于充电状态时,充电LED指示灯变红。...