Page 4
RF energy set by the Federal Communications Commission (FCC) of the United States. European Conformity Statement Unitech Electronics co., Ltd herewith declares that the Unitech product is in compliance with the essential requirements and all other provisions of the RED 2014/53/EU directive.
Page 6
Waste electrical and electronic equipment (WEEE) Unitech has set up a policy and process to meet the 2012/19/EU concerning electronic waste disposal. For more detailed information of the electronic waste disposal of the products you have purchased from Unitech directly or via Unitech’s resellers, you shall either...
Laser Information The Unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1. Class II and Class 2 products are not considered to be hazardous. The Unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
It may not be functional anymore. Please only use the original battery from Unitech. Using a third party battery can damage our products. Please note that when such damage occurs, it is not covered by Unitech’s warranty policy.
Unitech product for charging. Please remove the power adapter when the battery is fully recharged. The bundled power adapter that comes with your Unitech product is not meant to be used outdoors. An adapter exposed to water or rain, or a very humid environment can cause damage to both the adapter and the product.
Worldwide Support Unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest Unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan –...
The warranty period is varied from each country. Please consult with your supplier or Unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user.
MS852P User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the MS852P gift box. If something is missing or damaged, please contact your Unitech representative. The Package Contents Dongle MS852P with battery ...
1. Long press the trigger key for 2 seconds until you hear a long beep sound to turn on the MS852P. Scan the MAC address on the dongle with MS852P. Insert a dongle into a USB port of the computer or laptop PC.
Page 22
- Connect cradle to PC or an adaptor and plug in the socket. - Place the MS852P scanner into the cradle under power off condition. Press and hold the cradle button and MS852P trigger key for around 2 seconds, release after you hear beeper sound. It means MS852P scanner has enter firmware update process.
Page 23
Open a word processing program such as Microsoft Word or Notepad, and scan the following barcode: If the word “Unitech” appears on the screen, you have successfully installed your scanner. Note: To scan a barcode, make sure the aiming beam crosses every bar and space of the barcode.