Advertisement
Step 4: Adjust Range of Motion
Adjust the Monitor Arm (14) for both arms
Adjust the swivel using the 5mm Hex Key (F) at position 1. Adjust the tilt by using the 5mm Hex Key (F) at position 2.
Out of the box setting: 11-51 lbs
Balance the monitor with the Monitor Arm
using the 5mm Hex Key (F) at position 3. Set
the monitor to the middle height. If the monitor
drifts down, screw in the "+" direction. If the
monitor drifts up, screw in the "-" direction.
Adjust until it does not drift, then the monitor
will be balanced with the arm.
Caution:
Do not rotate the monitor arm away from the tabletop.
This could cause the table to be unstable.
Step 5: Rotate the Monitor Arm
For small monitors, rotate the upper arm to close the gap between the two monitors.
5mm
F
P a g e | 7
Advertisement
