Related Manuals for CABINETS TO GO Findley & Myers LCD2484
Summary of Contents for CABINETS TO GO Findley & Myers LCD2484
- Page 1 Pantry Cabinet with 3 Drawers ASSEMBLY INSTRUCTIONS These assembly instructions are only applicable for all Pantry Cabinets with 3 Drawers. ITEM #LCD2484, LCD2490, LCD2496 Page 1...
- Page 2 ► General Instructions: Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed to face the test of daily use and guaranteeing your enjoyment for many years to come. Carefully read the instructions before starting the installation. During assembly, please follow all generally accepted safety procedures. Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant damage and/or injury. Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist. Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will not be held responsible for failure to follow these instructions. PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT 1-800-CABINET.
- Page 3 NOTICE If the LCD you are installing runs the length of your ceiling height, it is recommended to assemble the unit standing to avoid scraping your ceiling. Instructions: ► Put the Back Panel (D) face up on a flat soft working surface to ensure that the surface is not scratched or damaged. Attach the drawer rail holders (c) to the pre-spotted areas using the supplied screws. (Figure 1) Qty 6 Top ...
- Page 4 assemble the drawer front (G) with drawer box front Drawer Assembly (Figure 7): First (H) with screws (b). Then assemble the rest of the parts of the drawer box (H) using your palm, or a rubber mallet if needed, to secure the dove tails into position. Repeat step for additional drawers.