Table of Contents
Advertisement
gas valve / regulator hose connection (Figure 9)
To perform a leak test:
1. Make 2~3 oz. of leak solution by mixing one part liquid dishwasher detergent and three parts water. Noted: make
sure control knob is "OFF".
2. Apply several drops of solution where the cylinder attaches to regulator, (see Figure 7), inspect the solution at
the connection looking for bubbles. If NO bubbles appear, the connection is secure. If bubbles appear, the
connection has the leak, disconnect the regulator, reconnect, perform another leak check. If you continue to see
bubbles after several attempts, cylinder valve is defective and should be returned to cylinder's supplier.
3. Apply several drops of solution where gas valve attaches to bellows, (see Figure 8), where gas valve attaches to
regulator hose, (see Figure 9), and where inlet tube attaches to bellows, (see Figure 10). If NO bubbles appear,
the connections are secure. If bubbles appear, the connection has the leak, disconnect, reconnect, perform
another leak check. If you continue to see bubbles after several attempts, both parts are defective and should
replace with the new ones.
1. Push in gas control knob slightly and turn to "OFF".
2. Turn gas control knob to "ON/MIN".
3. Push in gas control knob all the way and hold. Continue to press the ignition button for 15 seconds.
4. If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5 minutes before
attempting to light the burner again and repeat step 1 to 3.
1. Push in gas control knob slightly and turn to "OFF".
WARNING: For your safety, read and follow the Lighting Instructions in this manual and in the Rating Plate on the
appliance. IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR EXPLOSION
HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS
LIGHTING INSTRUCTIONS
1. Push in gas control knob slightly and
turn to "OFF".
2. Turn gas control knob to "ON/MIN".
3. Push in gas control knob all the way
and hold. Continue to press the
ignition button for 15 seconds.
4. If the burner does not light in 15
ON/MIN
seconds, release the knob and it will
(ENC./MÍN.)
pop back out. Wait 5 minutes before attempting
to light the burner again, repeat step 1 to 3.
TO TURN OFF GAS
1. Push in gas control knob slightly and turn to "OFF".
INSTRUCCIONES DE ENCENDIDO
1. Presione ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado).
2. Gire la perilla de control del gas a "ENC/MÍN" (encendido/mínimo).
3. Presione la perilla de control del gas hasta el fondo y mantenga presionada.
Siga presionando el botón de encendido durante 15 segundos.
4. Si el quemador no se enciende en 15 segundos, suelte la perilla y esta
volverá a su posición hacia afuera. Espere 5 minutos antes de intentar
encender el quemador nuevamente, repita los pasos 1 al 3.
PARA CERRAR EL GAS
1. Presione ligeramente la perilla de control del gas y gírela a la
posición "APG" (apagado)
inlet tube / bellows connection (Figure 10)
gas control knob
OFF (APG. )
ignition button
M A X
( M Á X . )
1 AAA
IGNITOR
1.5V
( Encendedor )
Figure 11
07
Advertisement
Table of Contents
