Haier GE GFW510SCN0 Technical Service Manual page 60

Drain Pump Removal
1. Ensure water is drained from the washer as
explained in the Drain Filter section.
2. Remove the front panel (see Front Panel in
the Cabinet and Structure section of this
service guide).
3. Remove the tub to pump hose and drain hose
from the drain pump.
4. Disconnect the harness connectors from the
drain pump.
5. Remove two Phillips-head screws securing
the drain pump to the chassis bottom. Then
slide the pump toward the rear. This will
release the two stabilizing posts that go
through two rubber grommets in the chassis
front. Lift the pump out from the cabinet.
– 60 –